0345 004 4040 support@telappliant.com

Welcome to the Customer Help Centre

For information relating to the use of products and services provided by Telappliant

    Sorry, we didn't find any relevant articles for you.

    Send us your queries using the form below and we will get back to you with a solution.


    Configuring a Cisco SPA 112/122 with VoIPtalk

    The following guide is for configuring Cisco SPA 112/122 with your VoIPtalk account.

    You will need:

    • The VoIPtalk ID – In case you don’t know it, you can find it by logging to your VoIPtalk control panel at voiptalk.org
    • The VoIPtalk password –  Go to the bottom of the page in case you need assistance with it.
    • The Proxy /SIP Server – “voiptalk.org”
    • The Proxy port – “5060”
    • The Outbound proxy server – “nat.voiptalk.org”
    • The Outbound proxy port – “5065”


    1-) Connect the adapter via the internet port to your router, using an Ethernet cable. 

    2-) Connect the adapter via one of the phone port to an analogue phone.

    3-) Once the adapter has been powered on, lift the receiver and dial **** for the configuration menu.

    4-) When "Configuration menu" is heard, dial 110# to hear the IP address. Note it down.

    5-) On a computer which is connected to the same subnet as the adapter, open a web browser and type the full IP address (including the dots) into the address bar.

    6-) On the login screen that will appear, enter "admin" (case sensitive) as both username and password.


    7) Once you have logged in, you will see a screen like the one below:


    8) From the menu select the "Voice" Tab, then "Line 1" from the left side 

    menu. The main configuration settings will appear.


    9) Enter the details as follows:

    Proxy and Registration:

    Proxy: voiptalk.org

    Outbound Proxy: nat.voiptalk.org:5065

    Use Outbound proxy: Yes

     

    Subscriber Information: 

    Display Name: Your VoIPtalk Id

    Password: your VoIPtalk account password

    User Id: your VoIPtalk ID

     

    10-) If configured correctly, the configuration should look like this:

     

    Click submit to allow the adapter to save and reboot itself.

     

    To check if the Cisco is registered, dial 902 from the handset. if you hear a congratulation message, then the registration was successful.




     

     

     

    Was this article helpful?

    Still can't find what you are looking for?

    Our award-winning customer care team is here for you.

    Contact Support

    Powered by